Piping Clogs During Processing
Customer's Problem
During bead milling, the piping clogs and operation stops.
AIMEX's Proposed Solution
Solution Through Changing Operating Conditions
• If the powder has large particles that settle easily, the mill's pump flow rate can be increased.
Increasing the pump flow velocity prevents settling in the piping.
• In the pre-process of mixing powder and solvent into a slurry, the powder can be added while circulating only the solvent through the bead mill.
Once processed, the powder becomes less likely to settle. Adding easily settling powder to the mill little by little allows operation without clogging.
Solution Through Bead Mill Selection
• Reduce horizontal piping
• Increase flow velocity by using narrower piping
We design piping to suit your requirements.

In bead milling, results vary with operating conditions and formulation. Please feel free to contact us below to discuss whether your material can be processed.

